
By Charles Buell, Real Estate Inspections in Seattle
If you enjoyed this post, and would like to get notices of new posts to my blog, please subscribe via email in the little box to the right. I promise NO spamming of your email
Consulting on Building Science and Forensics in the Seattle Area (Formerly Charles Buell Inspections INC)

By Charles Buell, Real Estate Inspections in Seattle
If you enjoyed this post, and would like to get notices of new posts to my blog, please subscribe via email in the little box to the right. I promise NO spamming of your email

How does the house know which rules to break and which ones not to break?Take foundation bolting for example. It is a question I get asked often–is the house bolted to the foundation? Sometimes it is the client that is concerned, sometimes it is their insurance carrier that wants to know.Over the course my building career I have seen foundation bolting go from ½” bolts, 6-8 feet apart, with no washers under the nuts, to 5/8” bolts, every four feet, with 2” square-plate washers under the nuts. In addition to this bolting are all manner of seismic strapping and hold-down bracketss with bolts as big as 1-1/8” in diameter. And this is in residential construction–commercial construction is even more extensive.All of this is fine and dandy and will likely help your house do very well in seismic activity up to a 7 or a little higher on the Richter scale. After that, all bets are off supposedly–but still the amount of damage would have to be somewhat less.
Again I ask, “How does the house know which rules to break and which ones not to break?”
A while back, I inspected a house that was over 30 years old. Its age tells me that it has been through at least two fairly major earthquakes in this region–including the 2001 Nisqually Quake. The house had no visible damage and yet the foundation bolting–while present–looked like the following picture.
This bolting is almost worse than no bolting at all–as the sill plates are nearly completely severed every 6 feet.
So the insurance company wants to know if the house is bolted. Any inspector would be “nuts” to say that this foundation is “bolted” wouldn’t they? And yet the house is doing fine after 30 years and is “standing the test of time.”
The house has broken the “rules” and is doing fine. Keeping houses on their foundations is not restricted to, or dependent on, code requirements for bolting. There are many older homes in Seattle that are not bolted to their foundations at all and have little or no seismic damage going back to earthquakes even stronger than any this house wiggled through.
For example there was a method of pouring foundations in this area, that used to be very common, where the bottom plate of the wall was put right in the forms so that when the concrete was poured it actually came up higher on the plate all the way around the inside of the foundation. This created an installation where the wood walls were naturally locked in place laterally by the concrete wall itself.
The reason this 30 year old house has done so well is because of the many “steps” in the foundation. Stepping the foundation aids in interlocking the foundation and wood walls, thus restricting movement laterally. If we take the same house with a uniform foundation–with no steps–and did the same type of bolting as in the second picture, the house would likely not fare as well.
As you can see, answering the seemingly simple question of whether the foundation is bolted or not does not really provide much in the way real information to anyone.
How the house is performing in relation to its age and methods of bolting is much more useful information to provide.
Brand new homes, with no “history” represent other challenges in terms of how we discuss foundation bolting.
Certainly any reporting of foundation bolting is going to have to come with some “qualifiers.”
By Charles Buell, Real Estate Inspections in Seattle
If you enjoyed this post, and would like to get notices of new posts to my blog, please subscribe via email in the little box to the right. I promise NO spamming of your email

Beetles, they are “opportunistic” in the sense that moisture conditions have to be correct (conducive) for them to be present.
As a Licensed, Washington State, Home Inspector and a Licensed Structural Pest Inspector, if I found evidence of these critters in your home–either past or present–the following is what you would see in your Inspection Report: Moisture Ant colonies typically start in already decayed wood and are considered a secondary infestation. Their nests are designed to promote moisture and further decay of the wood they cover. Removal of the damaged wood and replacement with sound wood will be required in some cases. Moisture ants require moisture to thrive, and eliminating the moisture source must be part of control measures. Added to this statement would be their location and a description of the damage and the possible causes of the leaking. It might not be possible to determine the extent of damage, because the actual damage might be located much further away from where their visual signs are found.
For example, in this case, the Moisture Ant structure extending from the top of the foundation up to the floor structure.
While there was minor decay present in the wood covered by this structure, the bulk of any damage is likely above the floor structure somewhere else. In this case, the area of real damage is somewhere in the chase around the insert fireplace. It will likely be necessary to remove some of the siding to actually figure out how much damage there is and to determine the source of moisture that is, or was, supporting the colony. In this case, there was no present activity–the nest was only damp. There is not enough moisture being introduced for the structure to stay wet enough to support the colony. Given some elevated moisture, this indicates an infestation that is likely seasonal–when long periods of rain allow enough moisture into the area to support their presence.It is not unusual to see Moisture Ants come and go in the home as the moisture conditions come and go.Of all the insects we deal with as Structural Pest Inspectors, I think I am most fascinated with Moisture Ants. Partly because I know that they are not the “real” problem and the extent of damage is usually not going to ruin the house–like Anobiid Beetles can.You can think of Moisture Ants as sort of a “flag” waving at you. The flag is saying, “HEY, knucklehead, you have a leak over here!” When the leak is fixed, the ants go away. You don’t have to get out your arsenal of non-environmentally safe chemicals and, ATTACK! They are smart and know when they are not wanted–and simply leave.They build these marvelous structures called “carton” out of the materials they eat. Take a look at this picture of Moisture Ants carton behind a baseboard electric heater.
They have taken the wet cellulose fiber and turned it into some of the coolest carton I have found.
This wet “nest” now acts like a sponge and keeps surrounding wood structures wet. This extends the moisture into structures that were previously not wet. As this wood decays it too becomes food and habitat for the Moisture Ants–and the colony can grow. It is this ability to expand their nests into previously dry areas and causing decay/rot that gets them classified as a “wood destroying” insect.
In reality, whoever didn’t notice the leak, and fix the leak might also be considered a wood destroying organism. It is generally human beings that create the conditions that are conducive to many wood destroying insects in our homes.
By Charles Buell, Real Estate Inspections in Seattle
If you enjoyed this post, and would like to get notices of new posts to my blog, please subscribe via email in the little box to the right. I promise NO spamming of your email